FREE BOOKS

Author's List




PREV.   NEXT  
|<   178   179   180   181   182   183   184   185   186   187   188   189   190   191   192   193   194   195   196   197   198   199   200   201   202  
203   204   205   206   207   208   209   210   211   212   213   214   215   216   217   218   219   220   221   222   223   224   225   226   227   >>   >|  
ps), in series" listed in the table. Series on 115 Volt Line Amp. Hours No. of Cells No. 115 Volt Capacity Amperes in Series Lamps Required 5 Amp. Rate Approximate on Line 115 Volt ----------- ----------- ------------ -------------- 50 or less 0.05 3 5-15 watt, in series 50 or less 0.05 30 2-15 watt, in series 50 or less 0.05 45 1-15 watt, in series 50-100 0.10 3 3-25 watt, in series 50-100 0.10 3 1-25 watt, in series 50-100 0.10 45 2-25 watt, in parallel 100 or over 0.15 3 2-25 watt, in series 100 or over 0.15 30 1-25 watt, in series 100 or over 0.15 45 3-25 watt, in parallel Every two months interrupt the trickle charge long enough to add water to bring the electrolyte up to the proper level. When this has been done, continue the trickle charge. Before putting the batteries into service, see that the electrolyte is up to the correct level, and that the specific gravity of the electrolyte is 1.280-1.300. If necessary, give a short charge on the charging bench to bring the specific gravity up to the correct value. Dry Storage 1. Give the battery a complete charge. Pour out the electrolyte, and separate the groups. If the negatives have bulged active material, press them in the plate press. In batteries such as the Prest-OLite in which it is difficult to remove the plates from the cover, the groups need not be separated unless the negatives have badly bulged active material. It may not be necessary to separate the groups even then, provided that the positives are not buckled to any noticeable extent. If only a very slight amount of buckling exists, the entire element may be pressed by putting thin boards between the plates in place of the separators. 2. Immerse the negatives in distilled water for ten to twelve hours. If positives and negatives cannot be separated, wash each complete element in a gentle stream of water. 3. Remove plates from water and allow them to drain thoroughly and dry. The negatives will heat up when exposed to the air, and when they do so they should be immersed in the water again to cool them. Repeat this as long as they tend to heat up. Then all
PREV.   NEXT  
|<   178   179   180   181   182   183   184   185   186   187   188   189   190   191   192   193   194   195   196   197   198   199   200   201   202  
203   204   205   206   207   208   209   210   211   212   213   214   215   216   217   218   219   220   221   222   223   224   225   226   227   >>   >|  



Top keywords:
series
 

negatives

 

charge

 

electrolyte

 

groups

 

plates

 

complete

 
putting
 

gravity

 
material

active

 

batteries

 

correct

 

separate

 

bulged

 
specific
 

element

 
separated
 

parallel

 

positives


Series

 
trickle
 

amount

 

buckling

 

provided

 

exists

 

pressed

 
entire
 

extent

 

noticeable


slight
 

buckled

 
exposed
 

Repeat

 

immersed

 

distilled

 

Immerse

 

separators

 

twelve

 

stream


Remove

 

gentle

 

boards

 
battery
 
proper
 

interrupt

 
service
 

Before

 

continue

 

months