After sharpening, (see under sharpening, p. 117.) the order is
reversed for replacing the cutter. The cap is set at right angles to
the cutter, the cap-screw dropped into the slot, the cap is slid up
the slot, and turned into line with the cutter, and then slid down the
slot till the edge of the cap comes quite near the edge of the cutter.
Then the two are held firmly together with the left hand until the cap
screw is turned tight.

In replacing the cutter and cap in the plane, care should be taken not
to injure the edge and to see that the Y adjustment lever fits into
the little slot in the cap; then finally the lever is thrown down
tight. Then, by turning the plane sole upward and glancing down it,
the proper adjustments with the brass set-screw and lateral adjustment
lever are made. When the plane is not being used, it should rest
either on a pillow (a little strip of wood in the bench trough), or on
its side. In no case should it be dropped sole down flat on the bench.

The _block-plane_, Fig. 108, gets its name from the fact that it was
first made for planing off the ends of clap-boards, a process called
"blocking in".

[Illustration: Fig. 108. Section of Block-Plane.]

The names of the parts of the Bailey block-plane are[6]:

1. Cutter or bit or _plane-iron_.
2. Clamp or _lever cup_.
3. _Cap-screw_.
4. _Adjusting lever_.
5. _Adjusting nut_.
6. _Lateral adjustment_.
7. _Bottom_.
8. _Mouth piece_.
9. _Eccentric plate_.
10. _Knob_.

[Footnote 6: See footnote p. 70]

The block-plane was devised for use with one hand, as when it is used
by carpenters in planing pieces not readily taken to a vise or in
planing with a bench-hook. Hence it is made small, 3-1/2" to 8" long,
the clamp is rounded so as to act as a handle, and the cutter is
lowered to an angle of about 20 deg. to make the plane easy to grasp. The
lower angle of the cutter makes it necessary that the bevel be on the
upper side. Otherwise, to give clearance, the bevel would have to be
made so long and so thin as to be weak. By putting the bevel up, the
angle between the wood and the cutter is maintained practically as in
the smooth-plane. Since the block-plane is intended chiefly for use
on end grain, no cap is needed to break the shavings. The adjustable
throat makes it possible to cut a very fine shaving. To facilitate the
cutting action, several forms of block-planes with a very low angle
are now made.

Where both