FREE BOOKS

Author's List




PREV.   NEXT  
|<   14   15   16   17   18   19   20   21   22   23   24   25   26   27   28   29   30   31   32   33   34   35   36   37   38  
39   40   41   42   43   44   45   46   47   48   49   50   51   52   53   54   55   56   57   58   59   60   61   62   63   >>   >|  
down each inclined plane toward the bottom of valley, thereby becoming further compressed; whereas, should the natural ground be cut in steps, the puddle in setting tends to bulge at the side of each riser, as it may be termed, and so cause fissures. It will be noticed that the slopes of these earthwork dams vary from 7 to 1 to 2 to 1. The depths to which some puddle trenches are carried has been objected to by some engineers, and among them Sir Robert Rawlinson, as excessive and unnecessary, and, in the opinion of the latter, the same end might be obtained by going down to a depth say of 30 ft. only, and putting in a thick bed of concrete, and also carrying up the concrete at the back of the puddle trench, with a well for collecting water, and a pipe leading the same off through the back of the dam to the down stream side. An arrangement of this kind is shown in the Yarrow dam, Fig. 4. The thickness of the puddle wall varies considerably in the different examples given in the diagrams before you, a fair average being the Row bank of the Paisley Water Works, Fig. 6; and although in instances of dams made early in the century, such as the Glencorse dam--Fig. 5--of the Edinburgh Water Works, the puddle was of very considerable thickness, and it would appear rightly so. This practice does not seem to have been followed in many cases, as, for instance, again referring to the Dale Dyke dam, Fig. 2, where the thickness of the top was only 4 ft., with a batter of 1 in 16 downward, giving a thickness of 16 ft. at the base. For a dam 95 ft. in height this is very light, compared with that of the Vehui dam at Bombay, of which the engineer was Mr. Conybeare--Fig. 7--where the puddle wall is 10 ft. wide at the top, with a batter downward of 1 in 8, the Bann reservoir--Fig. 8--of Mr. Bateman's design, where the puddle is 8 ft. broad at the top, and other instances. The same dimension was adopted for the puddle wall of the Harelaw reservoir, at Paisley, by Mr. Alexander Leslie, an engineer of considerable experience in dam construction. There appears to be a question as to what the composition of puddle should be, some advocating a considerable admixture of gravel with clay. There is no doubt that clay intended for puddle should be exposed to the weather for as long previous to use as possible, and subject to the action of the air at any rate, of sunshine if there be any, or of frost. When deposited in the trench, it should be
PREV.   NEXT  
|<   14   15   16   17   18   19   20   21   22   23   24   25   26   27   28   29   30   31   32   33   34   35   36   37   38  
39   40   41   42   43   44   45   46   47   48   49   50   51   52   53   54   55   56   57   58   59   60   61   62   63   >>   >|  



Top keywords:

puddle

 

thickness

 

considerable

 

trench

 

concrete

 
Paisley
 

downward

 

engineer

 

reservoir

 

batter


instances
 

height

 

giving

 

compared

 

bottom

 

Conybeare

 

Bombay

 
valley
 

natural

 

practice


rightly

 

Bateman

 

referring

 

instance

 

compressed

 

previous

 
subject
 
weather
 

intended

 
exposed

action

 

deposited

 

sunshine

 
inclined
 

Harelaw

 

Alexander

 

Leslie

 

adopted

 
dimension
 

design


ground

 

experience

 

construction

 

advocating

 

admixture

 

gravel

 
composition
 
appears
 

question

 

Edinburgh