FREE BOOKS

Author's List




PREV.   NEXT  
|<   10   11   12   13   14   15   16   17   18   19   20   21   22   23   24   25   26   27   28   29   30   31   32   33   34  
35   36   37   38   39   40   41   42   43   44   45   46   >>  
d of (B) and cut off (B) as Fig. 4. Take about three or four turns towards the eye of the hook with (A), with two more turns tie in the body material (D) Fig. 4. Wind (A) back to the starting point, take a half hitch and let hang. Wind body material (D) to where (A) was left hanging. Wind (D) back and forth several times to form a tapered body, fasten with two or three turns and a half hitch with (A) Fig. 5. Next take hackle (E), and strip off soft web fibers on dotted line, Fig. E. Hold hackle {23} (E) by the tip with thumb and finger of the left hand, with the shiny side of the hackle to the right, place the butt diagonally under the hook and take four or five tight turns and a half hitch with (A) Fig. 6. Be sure that the hackle is tied on edgewise with the shiny side to the front. Now grasp the tip of the hackle with the hackle pliers and wind four or five turns clockwise around the hook. If the hackle starts winding edgewise it will go on without any trouble, if not better take it off and try again until you get the knack of tying the butt in at just the right angle. Take three or four turns over the hackle tip with (A) and clip off the tip close as Fig. 7. With the thumb and finger of the left hand, reach from under the hook and pull all the fibers down to the bottom, take three or four turns over them with (A) towards the barb of the hook, to hold them in place, and to keep them pointing well back, as Fig. 8. Next take a pair of matched (one right and one left) turkey, goose, or other wing feathers, Fig. A, and cut a section from each about 1/4" wide, place the two sections with tips even and concave sides together as Fig. B. Cut off the butt ends to the right length, that is so that the tips come even, or a little beyond the bend of the hook. Place on top of hook as Fig. 9 and tie on the same as previously explained in tying hair on Bucktails (Diagram 3, page 15, Figs. 4 and 10). Finish off with a smooth tapered head, two or three half hitches {24} and a couple of coats of good head lacquer, Fig. 10. Many patterns are tied palmer, that is the hackle is wound the whole length of the body. Many of the dry flies are tied this way, especially the Bi-visibles. To tie a palmer hackle, prepare the hackle by holding the tip of the hackle between the thumb and finger of the left hand, and with the thumb and finger of the right hand, stroke the fibers back so that they point towards the butt, instead of towards the tip, Fig.
PREV.   NEXT  
|<   10   11   12   13   14   15   16   17   18   19   20   21   22   23   24   25   26   27   28   29   30   31   32   33   34  
35   36   37   38   39   40   41   42   43   44   45   46   >>  



Top keywords:
hackle
 

finger

 
fibers
 

length

 
edgewise
 
palmer
 
tapered
 

material


concave

 

visibles

 

prepare

 

turkey

 

matched

 

feathers

 

sections

 

section


holding

 

previously

 

couple

 

hitches

 

stroke

 

lacquer

 

patterns

 

smooth


Bucktails
 
explained
 

Diagram

 

Finish

 

trouble

 

diagonally

 

dotted

 
pliers

clockwise
 

starting

 

hanging

 

fasten

 

pointing

 

bottom

 

starts

 
winding