FREE BOOKS

Author's List




PREV.   NEXT  
|<   112   113   114   115   116   117   118   119   120   121   122   123   124   125   126   127   128   129   130   131   132   133   134   135   136  
137   138   139   140   141   142   143   144   145   146   147   148   149   150   151   152   153   154   155   156   157   158   159   160   161   >>   >|  
scribed on page 174. As for the ammeter, if a motor-generator set, Tungar Rectifier or a charging-rheostat is used, the ammeter is always furnished with the set. If a lamp bank is used, a switchboard type meter reading to about 25 amperes is suitable. With the constant potential system of charging, the ammeters are furnished with the motor-generator set. They read up to 300 amperes. The bottles for the distilled water and electrolyte are not of special design and may be obtained in local stores, There are several special water bottles sold by jobbers, and they are convenient, but not necessary. Figure 133 shows a very handy arrangement for a water or acid bottle. [Fig. 67 Working drawing of eight foot charging bench] [Fig. 68 Working drawing of a ten foot charging bench] [Fig. 69 Working drawing of a twelve foot charging bench] [Fig. 70 Working drawing of a twelve foot charging bench (without drain rack)] [Fig. 71 Working drawing of a two man work bench to be placed against a wall] [Fig. 72 Working drawing of a double, four man work bench, with two tool drawers for each man] WORK BENCH A work bench is more of a standard article than the charging bench, and there should be no trouble in building one. Figure 38 illustrates a good bench in actual use. A vise is, of course, necessary, and the bench should be of solid construction, and should be given several coats of asphaltum paint. [Fig. 73 Working drawing of a two man, double work bench] Figure 71 shows a single work bench which may be placed against a wall. Figures 72 and 73 show double work benches. Note that each bench has the elevated shelf, which should not, under any consideration be omitted, as it is absolutely necessary for good work. The tool drawers are also very convenient. It is best to have a separate "tear down" bench where batteries are opened, as such a bench will be a wet, sloppy place and would not be suitable for anything else. It should be placed near the sink or wash tank, as shown in the shop layouts illustrated in Figures 136 to 142. SINK OR WASH TANK [Fig. 74] Fig. 74. Sink with Faucet, and Extra Swinging Arm Pipe for Washing Out Jars. Four Inch Paint Brush for Washing Battery Cases An ordinary sink may be used, as shown in Figure 74. This figure also shows a convenient arrangement for washing out jars. This consists of a three-fourths inch pipe having a perforated cap screw
PREV.   NEXT  
|<   112   113   114   115   116   117   118   119   120   121   122   123   124   125   126   127   128   129   130   131   132   133   134   135   136  
137   138   139   140   141   142   143   144   145   146   147   148   149   150   151   152   153   154   155   156   157   158   159   160   161   >>   >|  



Top keywords:
charging
 

Working

 

drawing

 

Figure

 

convenient

 

double

 

arrangement

 
Figures
 

Washing

 
drawers

twelve

 

suitable

 

bottles

 

furnished

 

ammeter

 
amperes
 

generator

 
special
 

sloppy

 

layouts


consideration

 
omitted
 

elevated

 

absolutely

 

illustrated

 

batteries

 

separate

 
opened
 

figure

 

washing


scribed
 

ordinary

 
Battery
 

consists

 

perforated

 

fourths

 

Faucet

 

Swinging

 

Tungar

 

constant


potential

 

ammeters

 

system

 
reading
 
bottle
 

jobbers

 
electrolyte
 

obtained

 

stores

 

distilled