are pulled to the rear and outward
so that the rear wall of the tent is stretched to complete the
rectangle. Wall pins are then driven through these loops. Each
corner pin should be directly in rear of the corresponding front
corner pin, making a rectangle. Unless the canvas be wet, a small
amount of slack should be allowed before the corner pins are driven.
According to the size of the tent, one or two men, crawling under
the tent if necessary, fit each pole or ridge or upright into
the ring or ridge-pole holes, and such accessories as hood, fly,
and brace ropes are adjusted. If a tripod be used an additional
man will go under the tent to adjust it. The tent, steadied by
the remaining men, one at each corner guy rope, will then be
raised. If the tent is a ward or storage type, corner poles will
now be placed at the four corners. The four corner guy ropes
are then placed over the lower notches of the large pins driven
in prolongation of the diagonals at such distance as to hold
the walls and end of the tent vertical and smooth when the guy
ropes are drawn taut. A wall pin is then driven through each
remaining wall loop and a large pin for each guy rope is driven
in line with the corner guy pins already driven. The guy ropes
of the tent are placed over the lower notches, while the guy
ropes of the fly are placed over the upper notches, and are then
drawn taut. Brace ropes when used, are then secured to stakes
or pins suitably placed.
800. Rescinded.
CONICAL WALL TENT.
801. Drive the door pin and center pin 8 feet 3 inches apart.
Using the hood lines, with center pin as center, describe two
concentric circles with radii 8 feet 3 inches and 11 feet 3 inches.
In the outer circle drive two door guy pins 3 feet apart. At
intervals of about 3 feet drive the other guy pins.
In other respects conical tents are erected practically as in
the case of pyramidal tents.
TO STRIKE COMMON, WALL, PYRAMIDAL, AND CONICAL WALL TENTS.
802. STRIKE TENTS.
The men first remove all pins except those of the four corner
guy ropes, or the four quadrant guy ropes in the case of the
conical wall tent. The pins are neatly piled or placed in their
receptacle.
One man holds each guy, and when the ground is clear the tent
is lowered, folded, or rolled and tied, the poles or tripod and
pole fastened together, and the remaining pins collected.
TO FOLD TENTS.
803. For folding common, wall, hospital, and storage tents: Spread
|