.)

[Illustration: Fig. J.]

An awl-point arrow is made by inserting the point in the end of the
arrow, wrapping with copper wire, and getting a tinner to drop some
solder at the end to fasten the wire and awl-point firmly together. The
awl-point looks like this: (Fig. K.)

[Illustration: Fig. K.]

The awls (like Fig. L.) are filed like this into teeth-like notches on
the part going into the wood, and roundly sharp on the other part thus:
(Fig. M.)

[Illustration: Fig. L.]

[Illustration: Fig. M.]

These may be shot into an oak-tree and extracted by a twist of the hand
close to the arrow-point.

[Illustration: Fig. N.]

The broad-head hunting-point (Fig. N.) is put on by slitting the arrow
and inserting the flat handle of the arrow point, and wrapping it with
silk, sinews, or copper wire. These points can be sharpened along the
line A B on a whetstone, and will cut like knives. The hunting arrow
looks like this: (Fig. O.)

[Illustration: Fig. O.]

To feather an arrow you strip a goose feather from the quill and, after
clipping off the part near the quill-end, you mark a line down the arrow
from a point one inch from the nock and, spreading some Spaulding's glue
along that line apply the feather, lightly pressing it home with
forefinger and thumb. After you have glued on one piece lay aside the
arrow and fix another, and so on until the first is set, so that you may
put on another piece. When you have fastened these feathers on each arrow
lay them aside for ten or twelve hours. The three feathers will look like
this: (Fig. P.)

[Illustration: Fig. P.]

A boy can hardly make a good quiver unless he were to kill some furred
animal and make a cylindrical case such as the Indians have, out of its
skin. I am afraid that he usually would have to get a harness-maker to
make him a quiver out of leather, somewhat larger at the top than at the
bottom. It should hold from eight to twelve arrows.

A good target may be made of soft pine, circular or elliptical in shape.
In the latter case a line-shot might count, even though it were farther
from the centre. Pieces should be tacked to the back of this target at
right angles to the grain of the wood. Differently-colored circles or
rings, a little more than the width of an arrow, must be painted on this,
with a centre twice the width of an arrow. The outer ring counts one, the
next two, three, four and so on to the centre, which of course counts
highest. By this plan