been warmed, which should be done if possible,
the glue is spread on them, Fig. 260, and they are then rubbed slowly
back and forth in the direction of the grain, pressure being applied
by the hand and care being taken not to open the joint in the least.
As the glue sets, the rubbing becomes more difficult. It should be
stopped when the boards are in their proper relative positions. In
rubbing together the edges of two boards, handscrews may be fastened
to one in such a way that their jaws serve as guides for the other
board to slide between, Fig. 261. Care must be taken to make the jaws
of the handscrew diverge enough not to pinch the upper board.

[Illustration: Fig. 261. Rubbing a Glued Joint.]

Another method is to clamp a spare board alongside and projecting
above the lower board. This spare board acts as a guide against which
the upper board can be pushed as it is rubbed back and forth. The
rubbed joint is especially suitable for short boards.

In joining long boards, a squeezed joint is common. In this case, the
edges are planed so as to be very slightly concave from end to end.
The object of this is to counteract the subsequent shrinkage which is
likely to take place at the ends of the boards before it does at the
middle. The pressure of the clamps may be depended upon to close up
the middle, and, especially if dowels are inserted, as in No. 75, the
joint will be strong enough to resist the elasticity of the boards.

When the fit is good, warm the wood if possible, prepare the clamps,
put a thin film of glue over both edges which are to be together,
apply the clamps rapidly, keeping the faces flush, and set away to dry
for at least six hours. Then another piece may be added in the same
manner. If the boards are thin and wide, and therefore likely to
buckle, they may first be handscrewed to cross-strips to prevent their
buckling. The cross-strips are, of course, slightly shorter than the
combined width of the boards so that the full pressure of the clamps
may come on the glued joint.

_No. 71. A rebated, rabbeted or fillistered joint_, Fig. 269. Rebating
is the cutting of a rectangular slip out of the side of a piece of
wood. The re-entering angle left upon the wood is called the rebate or
rabbet. A rebated joint, then, is one in which corresponding rebates
are taken off edges so that the joined boards may overlap. It is used
in flooring and siding.

A board is rebated and filleted when two adjoining rebat