FREE BOOKS

Author's List




PREV.   NEXT  
|<   50   51   52   53   54   55   56   57   58   59   60   61   62   63   64   65   66   67   68   69   70   71   72   73   74  
75   76   77   78   79   80   81   82   83   84   85   86   87   88   89   90   91   92   93   94   95   96   97   98   99   >>   >|  
ity of its taking two victims at the same time. It may be set for rabbits, mink, or muskrat, and will be found very efficient. [Illustration] It consists of a box about eight inches square, one foot in length, and open at both ends. In the centre of the top board a hole of the diameter of a lead pencil should be bored, and a smaller aperture also made in the middle of each end near the edge as seen in the accompanying engraving. The spring is next required. This should consist of an elastic switch or small pole, three or more feet in length. It should be inserted in a slanting auger hole, made through the middle of one of the side boards near the bottom at the angle shown at (_a_). Should the switch fit loosely it may be easily tightened by a small wedge driven in beside it. The bait stick (_b_) should be about four inches in length, and large enough to fit easily into the hole in the centre of the top board. Next procure a stout bit of cord about eight inches in length. Tie one [Page 58] end to the tip of the switch and provide the other with a large double knot. A second knot should then be made, about an inch and a half above the first. A piece of sucker wire is the next necessity. Its length should be about five feet, and its centre should be tied over the uppermost knot in the string. If the bait is now in readiness, the trap may be set. Bend down the switch until the end knot will pass through the hole in the centre of the board. When it appears in the inside of the box, it should then be secured by the insertion of the top of the bait stick, as shown at (_b_). This insertion need be only very slight, a sixteenth of an inch being all that is sufficient to prevent the knot from slipping back. The spring is thus held in the position seen in the drawing, and the loose ends of the sucker wire should then be passed downward through the small holes and arranged in nooses at both openings of the box. Our trap is now set, and the unlucky creature which attempts to move that bait from either approach, will bring its career to an untimely end. The bait stick may be so delicately adjusted as to need only the slightest touch to dislodge it. Such a fine setting is to be guarded against, however, being as likely to be sprung by a mouse as by a larger animal. The setting is easily regulated, being entirely dependent upon the slight or firm insertion of the bait stick. Among all the "modi operandi" in the construction of tr
PREV.   NEXT  
|<   50   51   52   53   54   55   56   57   58   59   60   61   62   63   64   65   66   67   68   69   70   71   72   73   74  
75   76   77   78   79   80   81   82   83   84   85   86   87   88   89   90   91   92   93   94   95   96   97   98   99   >>   >|  



Top keywords:
length
 

centre

 

switch

 
easily
 

insertion

 

inches

 
spring
 

slight

 

sucker

 
setting

middle

 

animal

 

untimely

 
regulated
 
secured
 

sixteenth

 

inside

 

slipping

 
prevent
 

sufficient


dependent

 

sprung

 

larger

 

operandi

 

construction

 

readiness

 

appears

 

unlucky

 

creature

 

openings


arranged

 

nooses

 
slightest
 

delicately

 

adjusted

 
attempts
 

dislodge

 

position

 

career

 

drawing


guarded

 

downward

 
passed
 

string

 

approach

 
aperture
 

smaller

 
pencil
 
accompanying
 
engraving